FindStatGen & Tab names by NoPogo - 2013-08-20

Hello,

my problem is maybe not FSG specific. But in this macro I noticed it.

The following is happen:

I run my FSG from another macro file, this way:

CODE

$ExternalSettings = 1 Macro File="FindStatGen3.gsk" $ExternalSettings = 2 Macro File="FindStatGen3.gsk"

And, I have some tab names in the note section.

The tabs from the first output (settings 1) are always correct.

The tabs from the second (and all follwing) output (settings 2 or 3 or 4) are always the same, as settings 1.

If I run the findstatgen3.gsk manualy, and load the setting 2 (or 3 or 4), then the output is correct.

I attach a screenshot.

Is there a way to "unload" the settings?